Inspection lot after goods issue on Prod Order

Hi Gurus,

My client would like to perform a basic re inspection of the components before using them in manaufacturing.

In SAP this corresponds to Inspection Category : 02 - Insp lot w good issue

Then an inspection lot is created when I perform my picking by CO27 (or goods movement with MB1A)

However phisically the component/raw material is not yet consumed when I perfom my good issue. Some of them could be refused by quality departement. But the 261 mvt is performed on the prod order without a positive/negative UD code.

I made also the experience to refuse the inspection lot, no goods movement reversal has been notified.

Thanks for your time.

Regards