Hi everyone.
I have QM module defined so that no inspection posts into quality inspection stock. However, during configuration, for the one plant InspTypeForInspStock was the original 0800 (which posts to quality inspection) instead of a newly created Z0800, which doesnt post to quality inspection. Inspection type 0800 is not set to this material (nor to any other).
During a procedure in production, reversal of scrap, movement type 552 triggered moving the quantity for this material into quality inspection stock. No inspection lot was created. How can I move this from quality inspection stock to unrestricted stock, where it should be?
What I have tried is following:
- running QA08, mass processing, and adding Inspection Type 0800 to the material which was incorrectly posted; the system recognizes the material, but does not create any inspection lot (I have createdmaintained inspection plan for this material for both origins 9 and 5)
- transaction MB1B with movement type 321 gives the error that this movement should be done via QA11
- QA11 nor QA32 do not display any inspection lot for the stated material (without any other filter, dates wide open)
- MB52 shows the quantity on the quality inspection stock
- In table MCHB there is one item with the stated quantity for the material and its shown that it is in the inspection stock
What should I do to move this material from the quality inspection to the unrestricted stock?
Thanks in advance!
Marko